The slitting machine is a machine that cuts the strip into several required specifications. The base is welded by steel and steel plates. What are the adjustment problems when installing the slitting machine?
In order to ensure the stable operation of the slitting machine in the later stage, the plane positioning should be done first during the installation process. Considering the installation requirements, the equipment needs to be accurately positioned on the foundation first. After the equipment is hoisted in place, the reference line should be hung according to the set center mark plate. The reference line should be hung according to the installation accuracy requirements of the slitting machine equipment and the hanging span. A whole steel wire with a diameter of 0.3 to 0.75 mm should be selected.
In the process of hanging the reference line, the span of horizontal or inclined hanging is preferably within 40 meters, and at the same time, it is necessary to ensure that its tension is maintained at 40% to 80% of the breaking tension of the steel wire. The reference line should be hung on a wire rack that is easy to adjust, and the center point should be aligned with a plumb bob. After aligning the center, the steel wire should be locked with a lockable pulley so that the steel wire does not move during use. However, regular re-inspections should be carried out during use to prevent the steel wire from shifting.
Secondly, the elevation of the slitting machine equipment needs to be adjusted. Usually, when setting its elevation, the working surface of the equipment is mainly used as the measurement reference or measurement reference surface. According to the permanent reference point, an auxiliary reference point can be set near the equipment to facilitate the elevation adjustment of the equipment during installation.
Next, the levelness of the slitting machine equipment needs to be adjusted accordingly. Usually, if it is installed as a whole, it is necessary to directly measure the working surface of the equipment or the surface of the assembly joint with a level meter. According to the installation accuracy of the equipment, different precision levels can be selected, and the highest square level of 0.02mm/m can be selected.
If it is installed separately, it needs to be leveled separately. In addition, the plumbness of the slitting machine equipment needs to be adjusted. The plumbness adjustment of the slitting machine equipment can be measured by hanging steel wire measurement. A wire rack is set above the slitting machine equipment, a steel wire is hung on the wire rack, and a wire hammer is hung at the lower end. The wire hammer is placed in an oil barrel, and then the distance between the equipment and the steel wire is measured with an inside micrometer.






